The basement waterproofing systems and their working. To answer that question, let’s first look at historically conventional basement waterproofing and how it is supposed to work.
If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens:
A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.
The important point to note is the first one in the list above - that big hole in the ground. When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. This void gets filled with loose backfill. The problem here is that water looks for the path of least resistance, and you’ve just given it just that with a huge pile of loose backfill, no matter how well it’s been compacted.
This area is going to have water constantly seeping into it. The conventional basement waterproofing system provides some form of drainage pipe for this water to drain away, but the problem with this is that often these pipes get silted up. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. The system can overload if the pipes get over-filled and then the pressure of the built up water would be concentrated on the outer basement walls. If there are crevices in the walls, water will push through even if the basement walls are waterproofed.
The problem of this type is not easily rectified.The reason is that the pipes which are supposed to take away the excess water are gradually getting deteriorated and worsen over time.
A huge problem is that often there isn’t access to these pipes. Basement waterproofing is also applied to the external walls of the basement to try and keep the water out. Usually this is called a tanked system.
If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. To move water away from your property; it first must be collected and sent through drainage channels to a sump pump or a natural drainage field.
Basement waterproofing systems are reputedly a better system in that they are installed internally, have easy access ports for removing any silt and can be applied to basements where traditional tanking or other methods have failed but with minimal disturbance to the original basement.
In conclusion, you want a basement waterproofing system that will deliver:
- a permanent or long term fix
-stop water through the floor and walls
- not disturb landscaping, decks, patios, driveways, etc
- usually be an approved waterproofing method for home loans
- often be substantially cheaper than other waterproofing methods
You want to be sure to choose a reliable waterproofer for your home, keep in mind that it will greatly increase the value by far more than what you initally paid.
Waterproofing your home is an investment in its value.
Start using the waterproofing system for your basement with no hassle or hard work. If you wish the the basics and ensure that you have a hassle free and cheap experience, visit As with most companies you can now get information on basement waterproofing systems via an online website.